Panasonic, the manufacturer of the Leica CS35 tablet mainly used in conjunction with Leica Viva TPS & GNSS solutions, Leica Nova TS/MS Solutions and Leica Captivate Software, has issued an important safety notice in relation to the tablet’s battery pack. Under certain scenarios and for certain production lots, this pack can overheat and ignite.
Panasonic provides how to proceed on their official website. Panasonic outlines the risk scenarios, gives detailed instructions on how customers can identify affected units, and provides a step by step guides on how to proceed. Find detailed steps here: Panasonic Support Information
This issue affects only GLONASS-enabled receivers. GLONASS tracking will be temporarily interrupted on receivers operating during the introduction of the leap second on December 31st, 2016. GPS tracking will not be impacted, and receivers will continue to compute a position using the GPS constellation. OEM6 receivers may report a solution integrity warning during this period. GLONASS tracking will return to normal once a new GPS almanac is automatically downloaded from the satellites by the receiver. Receivers powered-up after the introduction of the leap second that do not have a current almanac will also temporarily have difficulty tracking GLONASS satellites. An almanac will not be available on start-up if the receiver has not been used in 90 days or if the almanac has been cleared manually by the user. GPS tracking will not be impacted, and receivers will continue to compute a position using the GPS constellation. OEM6 receivers may report a solution integrity warning during this period. GLONASS tracking will return to normal once a new GPS almanac is automatically downloaded from the satellites by the receiver.
In this video Jim will show you how to take downloaded data from Leica Viva SmartWorx into Leica Geo Office software. How to create a project, setup and apply proper coordinate system, and export data into an acsii file for use in your environment.
2. In data collector go to the Main Menu then 2 Jobs & Data:
-Select Job Properties and go to Coordinate Systems tab
-Choose desired coordinate system (or create new one) and press F3 Edit.
-Scroll down to Geoid File field and press Enter key.
– Select the New/desired Geoid file from selection – (may need to choose from Int Mem/Card via F6 key). Press F1 Store.
1. Transfer desired Geoid file to Internal Memory or Card in Geoid directory (Data/GPS/Geoid)
2. In Smartworx go to Main Menu then to 3 Coordinate Systems.
3. Choose desired coordinates system and press F3 Edit. Scroll down to Geoid file field and press ENTER key. Select new/desired Geoid file and press F1 Store.